Low-Gloss Additive

FLOR-FINISH™ Low Gloss additive is specifically designed to create a low gloss finish on polished concrete floors.

Product Description

Use FLOR-FINISH™ Low Gloss additive to produce polished concrete floors with a satin or low gloss finish. This flattening agent has been specially developed to be added to our standard FLOR-FINISH™ High Gloss material. After the application the gloss level on the floor will be an average of 15-25 points less than a normal reading of a digital gloss meter. The Low Gloss Additive will not affect the stain resistant properties of FLOR-FINISH™ in any way, making this a perfect choice for producing a low gloss finish.

Application Details

The application temperature range should be between 40-90 degrees F (5-32 C).
1. After the final polishing step has been completed the surface
should be thoroughly cleaned and burnished with a FLOR-GRIT
diamond impregnated Pad. Note: For the best results the last
diamond pass should not be higher than a 400 grit diamond.
The mechanical gloss level on the surface should not exceed 35-40        
before the application of the Low Gloss Additive.
2. Add a full 1 quart container of the Low Gloss Additive to 1 gallon
of FLOR-FINISH™ and mix throughly. You can add this directly into
a sprayer or a 2 gallon pail.
3. Note: You will need 1 quart of the Low Gloss Additive for each
gallon of FLOR-FINISH™ required. Keep the unused portion in a
seperate container and mark it clearly. Using the Low Gloss Additive
will extend your FLOR-FINISH™ coverage rate based on volume.
4. Apply FLOR-FINISH™ in the standard manner following all the
instructions provided in the FLOR-FINISH™ TIS sheet. Refer to the
FLOR-FINISH™ TIS sheet for complete application details.

Get the Low-Gloss TIS Sheet here